Welcome to King6Fabrications!
To browse our site please use the links above.
Providing Professional & Affordable options for the past 5 years!
Dedicated Mx6 -KL Motor Parts Fabrication.
Honest, Fair, & Fast turn around.
Workmanship Guarantee
Paypal Verified
Have any Ideas, Suggestions? Need a part that doesnt exist?
Send us an email !
To browse our site please use the links above.
Providing Professional & Affordable options for the past 5 years!
Dedicated Mx6 -KL Motor Parts Fabrication.
Honest, Fair, & Fast turn around.
Workmanship Guarantee
Paypal Verified
Have any Ideas, Suggestions? Need a part that doesnt exist?
Send us an email !
 |
 |
 |
 |
 |
 |
 |
Website designed by DKGRAFFIX Copyright 2010
REAR CROSS MEMBER & LOWER TRANS MOUNT
A K6F Custom. Each Cross Member can be designed to fit your custom setup, or be a lightweight stock replacement. Made from DOM materials. Designed around your needs, Up to 3inch of down pipe clearance can be added. Choose from the layout below or send me blue prints of the design you would like. I am open to options/improvements provided they can be done.
These cross members replace the stock side to side cross member on the sub frame.
They are commonly needed to allow fitment of turbo pipes or duel exhaust setups.
Shown is an example of a down pipe with clearance problems.
Every Cross member is Built to order. They are all made on a sub frame I have removed from a car,
this ensures they are a exact match to work on your car. They bolt on using your existing mounting bolts.
Specs:
Every Cross member is made from 1.0 OD DOM 1/8wall Tubing. Also 3/16 Flat Steel For gussets and supports.
If you would like other options,Email me with your request and estimate on any additional cost.
A K6F Custom. Each Cross Member can be designed to fit your custom setup, or be a lightweight stock replacement. Made from DOM materials. Designed around your needs, Up to 3inch of down pipe clearance can be added. Choose from the layout below or send me blue prints of the design you would like. I am open to options/improvements provided they can be done.
These cross members replace the stock side to side cross member on the sub frame.
They are commonly needed to allow fitment of turbo pipes or duel exhaust setups.
Shown is an example of a down pipe with clearance problems.
Every Cross member is Built to order. They are all made on a sub frame I have removed from a car,
this ensures they are a exact match to work on your car. They bolt on using your existing mounting bolts.
Specs:
Every Cross member is made from 1.0 OD DOM 1/8wall Tubing. Also 3/16 Flat Steel For gussets and supports.
If you would like other options,Email me with your request and estimate on any additional cost.
|
|
|
||||||
|
|
|
||||||
|
|
|
CROSS 1
CROSS 2
CROSS 3